#Alienware laptop m17x r3 skin drivers#
#Alienware laptop m17x r3 skin driver#
#Alienware laptop m17x r3 skin skin#

The m18x does have the throttle but doesnt have an issue hitting it like the m17x does. Thus, you might be fine a lot of the time, then hit a scene that is suddenly using the majority of the 384 shaders and your temp spikes.'ĩ. (Quoted from YodaGoneMad on ) 'There was that talk about the fact that what we see for GPU utilization is just a frame buffer, and that what really matters is the number of shaders used. The power throttling (movement to P1) takes place at 63CĨ. However, ambient temps will still play a role, and can help reduce laptop temps.ħ. Ambient temps are tested around 28C (a little over 80F), so ambient temps should not be a big concern under than mark.

#Alienware laptop m17x r3 skin drivers#

Seeing as shaders vary from one directx version to another, and different drivers can have their own set of variances which can impact use.Ħ.

#Alienware laptop m17x r3 skin driver#

Different directx versions, and driver versions can have a big impact. So the P0 state being the norm for high use, then clocks go down to P1 which is supposed to slow temp increase (essentially a 20% throttling), but not necessarily lower it, then once it hits 78C it goes into P8 state which then throttles it heavier.ĥ.

#Alienware laptop m17x r3 skin skin#

This is a big concern for the i/o port of the card, the skin temps, and other temp issues. and therefore more amps and current control issues. The heat comes from the fact that the 580m draws more power than the 6990 (about 20% more). The heat is actually pushed to the edge on the system. This is a 'duh' kinda thing, but explained more in the next point.Ĥ. Because of the smaller form factor, and the smaller fans, and the limited venting on the m17x r3 the heat increases more so than the m18x or desktops. When you repaste it with something different you are actually increasing the issue.ģ. The thermal paste on the 580m is better than mx4, arctic, etc. The only thing to void it would be if you do something to cause damage to it, with the exception of that damage happening through instruction of a tech on the phone leading you through the steps.Ģ. If you want to take apart every single screw and panel and part from your computer and reassemble it, repaste it, get out the paints and paint your name on it, or will still be under warranty. Repasting or doing any similar work on your computer WILL NOT VOID THE WARRANTY unless you break something. (please excuse the typos, I'm trying to wrangle my peanut butter covered son and type this at the same time lol)ġ.

I wont go into too many details about it, because some of the topics discussed are a little beyond the scope of the Facebook page, and, frankly, I may not remember every detail that was discussed, but here are some bullet points. The information is given with great thanks to the alienware and dell support agents, and to the community on Ĭonference call took place with dell reps, and I have to thank them for taking the time to have the conference call. The following is a transpose of my posting from the alienware facebook page, and I wanted to share the info wherever I can.